Dcp Board - Sony PMW-50 Service Manual

2-12.

DCP Board

Preparation
1. Remove the LCD assembly. (Refer to
2. Remove the top/bottom panel assembly. (Refer to
3. Remove the front panel assembly. (Refer to
4. Remove the rear panel assembly. (Refer to
5. Remove the bottom frame. (Refer to
6. Remove the front frame assembly. (Refer to
Procedure
1. Remove the two screws (P2 x 4) and the screw (P2.6 x 5) to detach the top frame.
2. Remove the three tapes AS or Three UL tapes.
3. Remove the tape (BT).
4. Remove the SDI cable cushion.
Tape (BT)
SDI cable cushion
Note
• When installing the tape, use the tape AS.
• Carefully attach the tape (BT) so that the coaxial cable does not touch the USB GND plate.
5. Remove the six screws to detach the heat spreader DCP.
6. Remove the two screws (P1.7 x 4) and the two screws (P2 x 4) to detach the HDMI bracket.
PMW-50
"2-2. LCD Assembly")
"2-3. Top/Bottom Panel
"2-4. Front Panel Assembly/SxS
"2-6. Rear Panel
"2-7. Bottom Frame")
"2-8. Front Frame
P2 x 4
P2.6 x 5
Tape AS
Coaxial cable
USB GND plate
Assembly")
Lid")
Assembly")
Assembly")
Top frame
P2 x 4
Tapes AS
2-24