Table of Contents
Advertisement
3.
Remove the shaft from the slit and then remove the SxS lid D assembly.
PVTP2 x 5
4.
Remove the two screws to detach the SxS window retainer and the SxS lid window.
5.
Disconnect the SxS lock holder from the two bosses on the SxS lock knob.
Note
When installing the SxS lock holder, fit the two bosses with the two holes.
6.
Disconnect the compression spring from the SxS lock knob.
Note
When installing the compression spring, set it at the position shown in the figure.
7.
Disconnect the two SxS knob sheets and the two SxS lid cushions from the SxS lid.
Bosses
SxS lock knob
Compression spring
SxS lid cushion (unreusable)
SxS lock knob
Compression
spring
8.
Install the removed parts by reversing the steps of removal.
9.
Firmly attach the SxS knob sheets. After the SxS lock holder and the SxS lock knob are installed, check whether
the SxS lock knob works smoothly.
PMW-50
SxS lid spring plate
SxS shaft retainer
SxS lid
SxS knob sheets
(unreusable)
SxS lock holder
SxS lid D assembly
Shaft
SxS lid cushion (unreusable)
Holes
SxS lid D assembly
Slit
SxS lid window
SxS window retainer
P1.7 x 4
P1.7 x 4
2-8
Advertisement
Table of Contents
