Add A Scan Setting Profile - Honeywell RT10A User Manual

Setting
Trigger Scan
Mode
Same symbol
timeout
Notification Settings
Use the Notification Settings to configure how your computer responds when you
scan a barcode.
Notification Settings
Setting
Good Read Notification
Bad Read Notification
Vibrate On Notification

Add a Scan Setting Profile

To create a scan setting profile for a custom app on the computer:
1. Swipe up from the bottom of the Home screen to access all apps.
2. Tap Settings
3. Tap
4. Take one of the following actions:
RT10A Rugged Tablet
Description
Set read behavior on scan button press. Options available:
•
•
•
•
Set the minimum buffer time in seconds before the scanner reads
the same barcode. This can be adjusted to prevent inadvertent
scans of the same barcode if the code is left in the scan field longer
than the Decode Timeout limit. The default same symbol timeout is
1000 seconds.
> Honeywell Settings > Scanning > Internal Scanner.
in the upper right corner of the app screen.
• Tap the profile name field. Add a new name, and then select OK.
OR
• Tap the select an application option, and then choose an app from the list.
The new profile appears on the Internal Scanner profile list. You can now select
and modify the scan settings for the new profile.
One Shot
Continuous
Read on release
Read on second trigger press
Description
Enables or disables a good read notification. The
notification consists of a green blink of the Scan Status
LED, a short beep, and an optional short vibration.
Enables or disables notification of a failed scan. The
notification consists of a red blink of the Scan Status LED,
an error beep, and an optional short vibration.
Enables or disables whether the computer vibrates when
there is a good or bad read.
Default
One
Shot
Disabled
Default
Enabled
Disabled
Disabled
33