Log Files - Honeywell RT10A User Manual

Configurations will be distributed to any client that connects to the server device.
Once the data transmission finishes successfully, the name and serial number of
the configured client will display in the Wi-Fi Staging app on the server device, and
the client device will skip the Android setup wizard.
Existing Devices
To start the Wi-Fi Staging client on an existing device:
1. Set up a server device (see page 62).
2. Turn on the client device and launch the Wi-Fi Staging app by tapping
3. Tap To be Staged.
4. A message will display notifying you that the Wi-Fi settings on the client device
5. Place the device within 1 meter (3 feet) of the server device and it will begin
The client devices will attempt to retrieve configuration from the server device and
a staging progress screen will display. Once the client device receives and applies
the configuration successfully, the progress screen will be dismissed.
Note: To stop the staging process on an existing device, tap the Back button on the client
device.

Log Files

Wi-Fi Staging saves a key process and exception log on the device in the following
directory: /sdcard/honeywell/Android/data/com.honeywell.wifistaging/Log/
This directory can be accessed through USB if Provisioning Mode is enabled.
RT10A Rugged Tablet
Settings > Honeywell Settings > Wi-Fi Staging.
will be reset as part of the staging process. Tap OK to confirm you wish to
proceed.
Staging will begin and a progress screen will display.
searching the server hotspot for a configuration.
65