New And Changed Features For Firmware Release 10.4(1)Sr1; Phone Setup; Adjust The Handset Rest - Cisco 7800 Series User Manual

New and Changed Features for Firmware Release 10.4(1)SR1

New and Changed Features for Firmware Release 10.4(1)SR1
Revision
Added Multicast paging support

Phone Setup

Your administrator sets up your phone and connects it to the network. If your phone is not set up and connected,
contact your administrator for instructions.

Adjust the Handset Rest

If your phone is wall-mounted or if the handset slips out of the cradle too easily, you may need to adjust the
handset rest to ensure that the receiver does not slip out of the cradle.
Figure 1: Adjust the Handset Rest
Procedure
Step 1
Remove the handset from the cradle and pull the plastic tab from the handset rest.
Step 2 Rotate the tab 180 degrees.
Step 3
Hold the tab between two fingers, with the corner notches facing you.
Step 4 Line up the tab with the slot in the cradle and press the tab evenly into the slot. An extension protrudes from
the top of the rotated tab.
Cisco IP Phone 7800 Series Multiplatform Phones User Guide
10
Updated Section
Page a Group of Phones (Multicast Paging), on page
50
Your Phone