Honda Acura NSX 1991 Service Manual page 1270

Wipers/Washers
-Windshield Wiper Motor
Replacement
1. Open the hood and remove the cap nuts and the
wiper arms.
NOTE: Carefully remove the wiper arms so that they
do not touch the hood.
2. Remove the windshield lower molding, hood seal and
air scoop by prying off the trim clips and removing
the screws. (see page 23-285).
3. Disconnect the 5-P connector from the wiper mo-
tor assembly, then remove the 2 mounting bolts and
the wiper linkage assembly.
WIPER LINKAGE ASSEMBLY
4. Remove the 3 mounting bolts and 1 nut from the
wiper linkage assembly to remove the wiper motor
assembly.
NUT
5. Install the wiper motor assembly in the reverse ord-
er of removal.
23-286
5-P COidNECTOR
MOUNTING
-Wiper/Washer Switch Replacement -
CAUTION:
All SRS electrical wiring harnesses are covered with
yellow outer insulation.
Replace the entire affected SRS harness assembly
if there is an open circuit or damage to the wiring.
1 . Remove the dashboad lower panel and disconnect
the 2-P connectors from the floor wire harness.
DASHBOAD LOWER
PANEL