Honda Acura NSX 1991 Service Manual page 1329

7. Install the steering wheel nut.
8. Install the airbag assembly.
STEERING WHEEL NUT
50 N.m (5.0 kg-m, 36 lb-ft)
Replace.
10 N.m (1.0 kg-m, 7 lb-ft)
Replace.
9.
Connect the harness from the cable reel to the SRS
main harness below the pedal bracket.
10. Connect the foot light harness and lights-on chime
to the dashboard lower panel, then install the lower
panel.
FOOT LIGHT
11. Disconnect the short connector from the airbag con-
12. Connect the battery positive terminal, then connect
TORX @ BOLT
13. After installing the cable reel, confirm proper sys-
10 N-m (1.0 kg-m,
7 lb-ft) Replace.
ASSEMBLY
ALIGNMENT MARK
nector and connect the cable reel and airbag harness.
NOTE: Attach the short connector to lid A, then in-
stall the lid.
the negative terminal.
tem operation:
SRS light should go on for about 6 seconds and
then go off.
l Confirm operation of horn buttons.
Confirm operation of the lighting and wiper
l
switches.
Confirm operation of cruise control set/resume
l
switch.
Rotate the steering wheel counterclockwise un-
l
til the yellow gear tooth lines up with the slot on
the cover.
YELLOW &EAR TOOTH