Install the Fan Tray
To install the fan tray in the rack, complete the following steps:
Note
If you are using more than one Cisco 6100 chassis in a Direct Connect with a POTS splitter
configuration, you must install a fan tray under each chassis.
Step 1
Place the fan tray chassis on a flat and stable surface (for example, a table top).
Step 2
Locate the first fan and unscrew the thumbscrew that holds the fan in place (the screw at the top of
each fan), as shown in Figure 4.
Figure 4
78-10158-01
Fan Tray Thumbscrews
STATUS
STATUS
Fan tray
thumbscrews
STATUS
Cisco 6100 Thermal Upgrade Kit Installation Procedures
Installing the Cisco 6100 Thermal Upgrade Kit
Cisco 6100
19