Cisco 6100 Installation Procedures Manual page 41

Install the plastic ESD shield over the DS3 subtending I/O card using the following steps:
Step 11
Position the holes in the plastic ESD shield over the existing standoff screws installed on the DS3
a.
subtending I/O card.
Use a Phillips-head screwdriver and the backplane screws you removed in the "Disconnect the
b.
Subtended Network Configuration" section on page 14 to attach the plastic ESD shield to the DS3
subtending I/O card (see Figure 27).
Figure 27
Existing
backplane
screw
78-10158-01
Plastic ESD Shield Installation
Existing
standoff
screw
TX 1
RX 1
TX 2
RX 2
Existing
standoff
screw
ESD
shield
Installing the Cisco 6100 Thermal Upgrade Kit
P1
P3
P2
P4
DS3
subtending
I/O card
Standoff
screw
Cisco 6100 Thermal Upgrade Kit Installation Procedures
41