Advertisement
Installing the Cisco 6100 Thermal Upgrade Kit
Carefully remove the fan by pulling it toward you. The fan is located on slide rails for easy removal
Step 3
and installation. (See Figure 5.)
Figure 5
STATUS
Place the fan on a flat and stable surface (for example, a table top) until you are ready to reinsert it into
Step 4
the fan tray.
Repeat Steps 2 through 4 for each fan.
Step 5
Position the fan tray chassis, which occupies 2 RUs of space, above the POTS splitter.
Step 6
Allow an additional 1 RU of space between the fan tray and the POTS splitter. This space allows for the
intake plenum and for cabling back to front for the OC-3c network interface module.
Use four mounting screws and a Phillips-head screwdriver to bolt the fan tray in the rack above the
Step 7
POTS splitter. See Figure 1 for the correct placement of the fan tray.
Align a fan with the fan tray slide rails inside the fan tray.
Step 8
Slide the fan into the fan tray.
Step 9
Tighten the thumbscrew above the fan.
Step 10
Repeat Steps 8 through 10 for each fan.
Step 11
For information about fan and air filter replacement, refer to the Cisco 6100 Series System
Note
Fan Tray Configuration Notes.
Cisco 6100 Thermal Upgrade Kit Installation Procedures
20
Removing the Fan from the Fan Tray
Fan tray
slide rails
STATUS
STATUS
Cisco 6100
78-10158-01
Advertisement
