Advertisement
Installing the Cisco 6100 Thermal Upgrade Kit
Installation Checklist
When you upgrade your Cisco 6100 chassis, be sure that you follow the installation procedures in the
proper sequence. Table 4 is a checklist of the installation steps in the order in which they should occur.
Caution
Proper ESD protection is required whenever you handle Cisco DSLAM equipment.
Installation and maintenance personnel should be properly grounded using ground straps
to eliminate the risk of ESD damage to the equipment. Modules are subject to ESD
damage whenever they are removed from the chassis.
Table 4
Check
Cisco 6100 Thermal Upgrade Kit Installation Procedures
10
Installation Checklist
Installation Procedure
1.
Remove the power from the system.
Measure the rack space.
2.
Disconnect the ViewRunner system (if applicable).
3.
Disconnect the network interface modules (if applicable).
4.
5.
Disconnect the subtended network configuration (if applicable).
Disconnect the Cisco 6100 power connections.
6.
Disconnect the Cisco 6100 from the Cisco 6120 (if applicable).
7.
Disconnect the Cisco 6100 chassis ground.
8.
9.
Stabilize the rack (if applicable).
Move any Cisco 6100 Series system hardware components (if applicable).
10.
Install the fan tray in the rack.
11.
Install the thermal guard on the Cisco 6100 chassis.
12.
13.
Install the filler faceplates in the open slots.
Ground the Cisco 6100.
14.
Ground the fan tray.
15.
Reconnect the Cisco 6100 chassis to the Cisco 6120 (if applicable).
16.
17.
Attach the Cisco 6100 power connections to the fuse and alarm panel.
Attach the fan tray power connections to the fuse and alarm panel.
18.
Connect the alarm contacts.
19.
The fan tray alarm contacts (P14, pins 7 and 8) on the chassis must be connected
Note
to the fan tray so that the alarms can be transmitted to the ViewRunner
management software.
Pull all of the modules away from the backplane connection.
20.
Verify that the DIP switches are set to the OFF position.
21.
22.
Reconnect the subtended network configuration (if applicable).
78-10158-01
Advertisement
