Assembling - Breville Antony Worrall Thompson JE15 User Manual

assembling

Be careful when handling the stainless steel filter. Do not touch the small sharp
blades inside the filter.
Place the motor base on a flat, dry surface such as your kitchen worktop. Ensure that the -
position switch is in the Off position, then switch the appliance off at the power outlet and unplug
the cord.
1. Fit the filter bowl onto the motor base. The spout on the filter bowl should be on the same
side of the motor base as the safety locking arm. When correctly fitted, the three triangular
'feet' on the bottom of the filter bowl sit in the three depressions on the top of the motor
base.
2. Align the arrows on the stainless steel filter basket with the arrows on the motor base drive
coupling and gently push the filter basket down until it clicks into place. Make sure that the
filter basket is fitted securely inside the filter bowl and onto the drive coupling.
3. Place the juicer cover over the filter bowl. The feed chute should be positioned over the
stainless steel filter.
4. Pivot the safety locking arm upwards until it engages with the two grooves in the juicer cover.
The safety locking arm should now be vertical and locked into place on the top of your juicer.
If the arm doesn't fit into place easily, don't force it. Check that you have fitted the juicer
cover correctly.
5. Tilt the large pulp container slightly and place it underneath the pulp outlet side of the juicer
cover.
6. Position the juice jug under the juice outlet spout on the right hand side of your juicer. If you
have fitted the lid to your juice jug, the spout needs to go through the hole in the side of the
lid.
7. Slide the food pusher into the feed chute. The food pusher has a groove in it which must be
lined up with the protrusion inside the feed tube.
8