Ntp-G40 Replace The Front Door - Cisco ONS 15454 M12 Maintenance Manual

NTP-G40 Replace the Front Door

Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Procedure
Step 1 Remove the dust plug from the fiber adapter.
Step 2
Insert a CLETOP stick swab (14100400) into the adapter opening and rotate the swab.
Step 3 Place dust plugs on the fiber adapters when not in use.
Step 4 Return to your originating procedure (NTP).
NTP-G40 Replace the Front Door
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Note
Be careful not to crimp any fiber cables that are connected to the MXP/TXP cards or DWDM cards. Some
might not have the fiber boot attached.
Procedure
Step 1
Insert the front door into the hinges on the shelf assembly.
Step 2 (ANSI only) Attach one end of the ground strap terminal lug (72-3622-01) to the male stud on the inside of
the door. Attach and tighten the #6 Kepnut (49-0600-01) using the open-end wrench.
Maintaining the ONS 15454 M12 (ANSI and ETSI), ONS 15454 M2 and ONS 15454 M6 Shelf
14
Maintaining the ONS 15454 M12 (ANSI and ETSI), ONS 15454 M2 and ONS 15454 M6 Shelf
None
Required
Onsite
None
This procedure replaces the front door and door ground strap after installing cards
and fiber-optic cables.
#2 Phillips screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
NTP-G259 Open and Remove the Standard Door of the ONS 15454 M6 Shelf
Required
Onsite
None