Cisco BWX 8305 Installation And Commissioning Manual page 73

Chapter 6 Installation
Latitude (*1E6)
Longitude (*1E6)
Height (cm)
Ethernet Link status
Started SNTP Server
Started SNMP Server
Started HTTP Server
Started Telnet Server
Telnet session active
>
Once the Position Mode field changes to Completed, verify that the Unit Mode field has changed to
Step 17
Locking and then to LOOP Mode GPS with a value of OK. (Refer to
Example 6-4
> status
PTF 3203A GPS receiver Software Version 2.27-2c, CPLD Version 10
Capabilities -> Normal + SNTP + SNMP + HTTP + TELNET
Unit Mode
Satellites tracked
Position mode
Latitude (*1E6)
Longitude (*1E6)
Height (cm)
Ethernet Link status
Started SNTP Server
Started SNMP Server
Started HTTP Server
Started Telnet Server
Telnet session active
>
>
> status
PTF 3203A GPS receiver Software Version 2.27-2c, CPLD Version 10
Capabilities -> Normal + SNTP + SNMP + HTTP + TELNET
LOOP Mode GPS
Satellites tracked
Position mode
Latitude (*1E6)
Longitude (*1E6)
Height (cm)
Ethernet Link status
Started SNTP Server
Started SNMP Server
Started HTTP Server
Started Telnet Server
Telnet session active
>
>
After the BWX 8303 Basestation Timing System has "locked" (Fault light off and solid green Locked
Step 18
LED), change the POS FIX MODE value to fixed, by typing the following command: A05 fixed
This will allow the BWX 8303 Basestation Timing System to initialize quickly the next time it is
booted-up.
OL-16336-02
22281290
114174952
13105
DOWN
NO
NO
NO
NO
NO
BWX 8303 Basestation Timing System Unit Mode Status Output
Locking
06
Complete
22281290
114174952
13105
DOWN
NO
NO
NO
NO
NO
OK
06
Complete
22281290
114174952
13105
DOWN
NO
NO
NO
NO
NO
Connect BWX 8303 Basestation Timing System
BWX 2305 Basestation Installation and Commissioning Guide
Example 6-4)
6-37