Cisco BWX 8305 Installation And Commissioning Manual page 26

Planning, Preparation and Pre-Configuration
4.2 Planning, Preparation and Pre-Configuration
Planning & Preparation
BWX 8305 Basestation Installation and Commissioning Guide
4-2
Start Start
Complete Project Plan Complete Project Plan
(Program or Project Manager) (Program or Project Manager)
Generate the Generate the
RF coverage prediction map RF coverage prediction map
(RF Engineer) (RF Engineer)
Conduct site survey & Conduct site survey &
complete the complete the Site Candidate Site Candidate
Evaluation Form Evaluation Form
Complete the Complete the
Interference Analysis Interference Analysis
Complete the Site Design Complete the Site Design
(Site Planner) (Site Planner)
Complete the Complete the Complete the Complete the
Network Architecture design Network Architecture design Network Architecture design Network Architecture design
Network Planning) Network Planning) (Network Planner) (Network Planner)
Select which cables to use Select which cables to use
(RF, CAL and GPS) (RF, CAL and GPS)
Develop the Bill of Materials. Develop the Bill of Materials.
Acquire all equipment, materials, Acquire all equipment, materials,
documents, and forms documents, and forms
Chapter 4 I&C Process
Pre-Configuration
Install & configure Install & configure
the "production" the "production"
EMS Server & Client EMS Server & Client
If not already in place If not already in place
Install & configure Install & configure
the 'test' the 'test'
EMS Server & Client EMS Server & Client
on your laptop on your laptop
Add additional Global Config Add additional Global Config
parameters as required by your parameters as required by your
company (if needed) company (if needed)
Add & configure a record Add & configure a record
for each CPE to be used during for each CPE to be used during
the commissioning tests. the commissioning tests.
A A
THE INSTALLER WILL DO THE INSTALLER WILL DO
ALL THE FOLLOWING ALL THE FOLLOWING
TASKS USING THE TEST TASKS USING THE TEST
EMS. THEN, WHEN THE BS EMS. THEN, WHEN THE BS
IS UP AND RUNNING AND IS UP AND RUNNING AND
ALL THE TESTS HAVE BEEN ALL THE TESTS HAVE BEEN
COMPLETED, THE BS IS COMPLETED, THE BS IS
"CUT OVER" TO THE "CUT OVER" TO THE
PRODUCTION EMS PRODUCTION EMS
OL-16336-02