Chapter 4 I&C Proces - Cisco BWX 8305 Installation And Commissioning Manual

Chapter 4 I&C Process
4.5 Commissioning
OL-16336-02
Commissioning – (for each BS at the cell site)
C C
Power up the BS. Power up the BS.
Change the boot-line parameters Change the boot-line parameters
to point to the BS record i n the to point to the BS record i n the
Test EMS. Test EMS.
Resume the boot Resume the boot
Wait 5 min after boot completes. Wait 5 min after boot completes.
Make sure that there are no Make sure that there are no
outstanding alarms and that the BS outstanding alarms and that the BS
is stable (not resetting) is stable (not resetting)
Perform 3 full calibrations Perform 3 full calibrations
If not successful, If not successful,
troubleshoot troubleshoot
and repeat and repeat
Y Y
Perform the RF Verification Perform the RF Verification
If not successful, If not successful,
troubleshoot troubleshoot
and repeat and repeat
Y Y
Perform the Location Test Perform the Location Test
and the Single Antenna and the Single Antenna
Element test Element test
not successful, not successful,
troubleshoot, troubleshoot,
recalibrate and recalibrate and
Perform the Drive Test Perform the Drive Test
Complete the I&C Closeout Tool Complete the I&C Closeout Tool
N N
Gather all the Closeout Gather all the Closeout
documentation files and zip them documentation files and zip them
Take pictures Take pictures
Gather all the Closeout Gather all the Closeout
documentation files and zip them documentation files and zip them
N N
to Operator to Operator
NOW YOU CAN CUT THE BS NOW YOU CAN CUT THE BS
OVER TO THE PRODUCTION OVER TO THE PRODUCTION
BWX 8305 Basestation Installation and Commissioning Guide
Commissioning
If If
N N
repeat repeat
Y Y
D D
EMS EMS
4-5