Commreq #25: Write Data Command - GE GFK-2892F User Manual

COMMREQ #25: Write Data Command

This command is used to set data values in a Genius High-speed Counter.
Command Block for the Write Data Command
Address Command Length
Address +1 No Wait
Address +2 Status Block memory type
Address +3 Status Block offset
Address +4 Idle timeout value
Address +5 Max. communications time
Address +6 Command number
Address +7 PROFINET Device number
Address +8 Genius Device Number
Address +9 Command Code
Address +10 Counter Number
Data to be written
Address +11
bytes 1, 2
Address +12
bytes 3, 4
GFK-2892F
Chapter 6. COMMREQ/Data_Init_Comm Programming
7
0
70 (%I), 72 (%Q), 8 (%R), 10 (%AI), 12 (%AQ) or 196 (%W)
Beginning address for the COMMREQ Status Block.
0
0
25
1-255: The device number of the targeted GCG Genius Gateway.
1-29: the SBA of the targeted Genius Device to which data is to be
transmitted.
See Read/Write Data Command Code Table below.
1-4
Four bytes of data to be written to the target Genius HSC
(Byte 4 is MSB, Byte 1 is LSB)
March 2019 83