Specifications - GE GFK-2892F User Manual

1.6 Specifications

RX3i Genius Communications Gateway Specifications
PROFINET Support
CPU Compatibility
PNC001 Compatibility
Embedded PROFINET
Compatibility
Proficy* Machine Edition
Compatibility
Power Requirements
Operating Temperature Range
Number of Port Connectors
Local Area Network (LAN)
Status Data
Genius Bus Support
HHM Compatibility
Other Genius Compatibility
SD Card
Configuration
Hot Swappable
For system standards, general operating specifications, and installation requirements, refer to the PACSystems
RX3i System Manual, GFK-2314.
GFK-2892F
PROFINET version 2.3 Class A IO-Device
RX3i CPE330
RX3i CPE302/CPE305/CPE310 with firmware version 8.15 or later
RX3i CPU315/CPU320/CRU320 with firmware version 8.15 or later
Rx3i CPE302 (any firmware version)
Firmware version 2.05 or later
RX3i CPE400 embedded PROFINET
RX3i CPE330 embedded PROFINET with firmware version 8.90 or
later
PME 8.0 or later
External 24Vdc: (±10%) 0.2A
0 to 60°C
Two RJ-45
IEEE 802.2 Logical Link Control Class I
IEEE 802.3 CSMA/CD Medium Access Control 10/100 Mbps
64 (two banks of 32 bits)
Supports One Genius Bus.
Serial 1, Serial 2, Shield In and Shield Out, as marked.
Up to 29 additional devices supported per Genius Bus.
Selectable Baud Rate, per Genius specifications.
Genius Hot Standby and Duplex Redundancy supported.
IC660HHM501
See table in Section 1.11
2GB or smaller. Not compatible with SDHC or SDXC cards.
GSDML file is available on the Support website for download and
import into PME. The GSDML supporting a firmware release is part
of the firmware upgrade kit available on the Support website.
The Genius Gateway requires an external 24Vdc power supply
and does not draw power from the Rx3i backplane. Swapping out
the GCG001 will therefore not impact the PLC. However, this
cannot be performed without disconnecting its power supply. If
configured to support Genius Hot Standby, the loss of a single
GCG001 will be tolerated; otherwise not.
March 2019
Chapter 1. Introduction
7