Fault Types Reported To The Rx3I Controller I/O Fault Table; Figure 27 - I/O Fault Table Message Identifiers - GE GFK-2892F User Manual

Chapter 5. Diagnostics

Fault Types Reported to the RX3i Controller I/O Fault Table

When imported into the Rx3i I/O Fault Table, the following Error Codes are displayed without explanation. The
following table is provided to assist in decoding the displayed error codes.
Fault Type Description
257 Internal Circuit fault
258 Shared RAM fault
259 Electronics Assembly EEPROM fault
260 Communication interface fault
261 Terminal Strip EEPROM fault or NVRAM fault
262 EEPROM fault
263 Private RAM fault
264 Processor fault
273 Failed Switch
274 Open Input / Over-Temperature
275 No Load Present
276 Overload
277 Short Circuit
278 Loss of I/O Power
289 Feedback Error
290 Output channel over-range
291 Output channel under-range
292 Input channel open wire
293 Input channel over-range
294 Input channel under-range
295 Input channel high alarm
296 Input channel low alarm
305 Input channel shorted
306 Internal channel fault
307 Input channel wiring error
308 Input channel open wire
309 Input channel over-range
310 Input channel under-range
311 Input channel high alarm
312 Input channel low alarm
400 unknown Error-Type
513 Field Control, VersaMax or S90-70 Remote Scanner I/O fault
769 S90-70 Remote Scanner I/O fault
1026 Invalid Genius Gateway module configuration
1027 Invalid Genius Gateway module configuration
1028 Extra Genius device
1029 Configuration mismatch in S90-70 Remote Scanner Rack
1030 Configuration mismatch in VersaMax I/O Station
1031 Configuration mismatch in Field Control I/O Station
1032 Mismatch between configured Genius device and actual device present.
1033
Genius device is present on the bus, but is not in the configuration.
46

Figure 27 - I/O Fault Table Message Identifiers

PACSystems RX3i Genius Communications Gateway GFK-2892F