Cisco ASA 5506-X Configuration Manual page 417

Chapter 18 ASA IPS Module
Command
Step 2
For a hardware module:
hw-module module 1 recover boot
For a software module:
sw-module module ips recover boot
Example:
hostname# hw-module module 1 recover boot
Step 3 For a hardware module:
show module 1 details
For a software module:
show module ips details
Example:
hostname# show module 1 details
Shutting Down the Module
Shutting down the module software prepares the module to be safely powered off without losing
configuration data. Note: If you reload the ASA, the module is not automatically shut down, so we
recommend shutting down the module before reloading the ASA. To gracefully shut down the module,
perform the following steps at the ASA CLI.
Detailed Steps
Command
For a hardware module (for example, the ASA
5585-X):
hw-module module 1 shutdown
For a software module (for example, the ASA
5545-X):
sw-module module ips shutdown
Example:
hostname# hw-module module 1 shutdown
Purpose
Installs and boots the IPS module software.
Checks the progress of the image transfer and module restart
process.
The Status field in the output indicates the operational status of
the module. A module operating normally shows a status of "Up."
While the ASA transfers an application image to the module, the
Status field in the output reads "Recover." When the ASA
completes the image transfer and restarts the module, the newly
transferred image is running.
Purpose
Shuts down the module.
Cisco ASA Series Firewall CLI Configuration Guide
Managing the ASA IPS module
18-19