Cisco ASA 5506-X Configuration Manual page 378

Defaults for ASA CX
Defaults for ASA CX
The following table lists the default settings for the ASA CX module.
Table 17-1
Parameters
Management IP address
Gateway
SSH or session Username
Password
Configure the ASA CX Module
Configuring the ASA CX module is a process that includes configuration of the ASA CX security policy
on the ASA CX module and then configuration of the ASA to send traffic to the ASA CX module. To
configure the ASA CX module, perform the following steps:
Connect the ASA CX Management Interface, page
Step 1
optionally, the console interface.
(ASA 5512-X through ASA 5555-X) Install or Reimage the Software Module, page
Step 2
(ASA 5585-X) Change the ASA CX Management IP Address, page
Step 3
required for initial SSH access.
Step 4 Configure Basic ASA CX Settings, page
Configure the Security Policy on the ASA CX Module, page
Step 5
(Optional.)
Step 6
Redirect Traffic to the ASA CX Module, page
Step 7
Cisco ASA Series Firewall CLI Configuration Guide
17-8
Default Network Parameters
Configure the Authentication Proxy Port, page 17-16
Default
ASA 5585-X: Management 1/0 192.168.8.8/24
ASA 5512-X through ASA 5555-X: Management 0/0
192.168.1.2/24
ASA 5585-X: 192.168.8.1/24
ASA 5512-X through ASA 5555-X: 192.168.1.1/24
admin
Admin123
17-9. Cable the ASA CX management interfaces and
17-14. You do this on the ASA CX module.
17-16.
17-16.
Chapter 17 ASA CX Module
17-11.
17-14, if necessary. This might be