Cisco ASA 5506-X Configuration Manual page 240

GTP Inspection
Example:
hostname(config)# policy-map global_policy
In the default configuration, the global_policy policy map is assigned globally to all interfaces. If you
want to edit the global_policy, enter global_policy as the policy name.
Identify the L3/L4 class map you are using for DCERPC inspection.
Step 3
class name
Example:
hostname(config-pmap)# class inspection_default
To edit the default policy, or to use the special inspection_default class map in a new policy, specify
inspection_default for the name. Otherwise, you are specifying the class you created earlier in this
procedure.
Step 4 Configure DCERPC inspection.
inspect dcerpc [dcerpc_policy_map]
Where dcerpc_policy_map is the optional DCERPC inspection policy map. You need a map only if you
want non-default inspection processing. For information on creating the inspection policy map, see
Configure a DCERPC Inspection Policy Map, page
Example:
hostname(config-class)# no inspect dcerpc
hostname(config-class)# inspect dcerpc dcerpc-map
Note
If you are editing an existing service policy (such as the default global policy called global_policy), you
Step 5
are done. Otherwise, activate the policy map on one or more interfaces.
service-policy policymap_name {global | interface interface_name}
Example:
hostname(config)# service-policy global_policy global
The global keyword applies the policy map to all interfaces, and interface applies the policy to one
interface. Only one global policy is allowed. You can override the global policy on an interface by
applying a service policy to that interface. You can only apply one policy map to each interface.
GTP Inspection
The following sections describe the GTP inspection engine.
GTP inspection requires a special license.
Note
Cisco ASA Series Firewall CLI Configuration Guide
10-4
If you are editing the default global policy (or any in-use policy) to use a different inspection
policy map, you must remove the DCERPC inspection with the no inspect dcerpc command,
and then re-add it with the new inspection policy map name.
Chapter 10 Inspection for Management Application Protocols
10-2.