Cisco ASA 5506-X Configuration Manual page 353

Chapter 16 ASA FirePOWER (SFR) Module
For example:
asasfr-boot> system install http://upgrades.example.com/packages/asasfr-sys-5.3.1-44.pkg
Verifying
Downloading
Extracting
Package Detail
Do you want to continue with upgrade? [y]: y
Warning: Please do not interrupt the process or turn off the system.
Doing so might leave system in unusable state.
Upgrading
Starting upgrade process ...
Populating new system image
Reboot is required to complete the upgrade. Press 'Enter' to reboot the system.
(press Enter)
Broadcast message from root (ttyS1) (Mon Feb 17 19:28:38 2014):
The system is going down for reboot NOW!
Console session with module sfr terminated.
Step 8 Open a session to the ASA FirePOWER module. You will see a different login prompt because you are
logging into the fully functional module.
asa3# session sfr console
Opening console session with module sfr.
Connected to module sfr. Escape character sequence is 'CTRL-^X'.
Sourcefire ASA5555 v5.3.1 (build 44)
Sourcefire3D login:
Log in with the username admin and the password Sourcefire.
Step 9
Complete the system configuration as prompted.
Step 10
You must first read and accept the end user license agreement (EULA). Then change the admin
password, then configure the management address and DNS settings, as prompted. You can configure
both IPv4 and IPv6 management addresses. For example:
System initialization in progress.
You must change the password for 'admin' to continue.
Enter new password: <new password>
Confirm new password: <repeat password>
You must configure the network to continue.
You must configure at least one of IPv4 or IPv6.
Do you want to configure IPv4? (y/n) [y]: y
Do you want to configure IPv6? (y/n) [n]:
Configure IPv4 via DHCP or manually? (dhcp/manual) [manual]:
Enter an IPv4 address for the management interface [192.168.45.45]: 10.86.118.3
Enter an IPv4 netmask for the management interface [255.255.255.0]: 255.255.252.0
Enter the IPv4 default gateway for the management interface []: 10.86.116.1
Enter a fully qualified hostname for this system [Sourcefire3D]: asasfr.example.com
Enter a comma-separated list of DNS servers or 'none' []: 10.100.10.15,
10.120.10.14
Enter a comma-separated list of search domains or 'none' [example.net]: example.com
If your networking information has changed, you will need to reconnect.
For HTTP Proxy configuration, run 'configure network http-proxy'
(Wait for the system to reconfigure itself.)
This sensor must be managed by a Defense Center.
registration key is always required.
Description:
Requires reboot:
Cisco ASA-FirePOWER 5.3.1-44 System Install
Yes
Please stand by.
A unique alphanumeric
In most cases, to register a sensor
Cisco ASA Series Firewall CLI Configuration Guide
Configure the ASA FirePOWER Module
16-13