Cisco ASA 5506-X Configuration Manual page 280

Configure QoS
Configure the Priority Queue for an Interface
If you enable priority queuing for traffic on a physical interface, then you need to also create the priority
queue on each interface. Each physical interface uses two queues: one for priority traffic, and the other
for all other traffic. For the other traffic, you can optionally configure policing.
Before You Begin
•
•
Procedure
Create the priority queue for the interface.
Step 1
priority-queue interface_name
Example:
hostname(config)# priority-queue inside
The interface_name argument specifies the physical interface name on which you want to enable the
priority queue, or for the ASASM, the VLAN interface name.
Change the size of the priority queues.
Step 2
queue-limit number_of_packets
Example:
hostname(config-priority-queue)# queue-limit 260
The default queue limit is 1024 packets. Because queues are not of infinite size, they can fill and
overflow. When a queue is full, any additional packets cannot get into the queue and are dropped (called
tail drop). To avoid having the queue fill up, you can use the queue-limit command to increase the queue
buffer size.
The upper limit of the range of values for the queue-limit command is determined dynamically at run
time. To view this limit, enter queue-limit ? on the command line. The key determinants are the memory
needed to support the queues and the memory available on the device.
The queue-limit that you specify affects both the higher priority low-latency queue and the best effort
queue.
Specify the depth of the priority queues.
Step 3
tx-ring-limit number_of_packets
Example:
hostname(config-priority-queue)# tx-ring-limit 3
The default tx-ring-limit is 128 packets. This command sets the maximum number of low-latency or
normal priority packets allowed into the Ethernet transmit driver before the driver pushes back to the
queues on the interface to let them buffer packets until the congestion clears. This setting guarantees that
the hardware-based transmit ring imposes a limited amount of extra latency for a high-priority packet.
The upper limit of the range of values for the tx-ring-limit command is determined dynamically at run
time. To view this limit, enter tx-ring-limit ? on the command line. The key determinants are the
memory needed to support the queues and the memory available on the device.
Cisco ASA Series Firewall CLI Configuration Guide
12-6
(ASASM) The ASASM does not support priority queuing.
(ASA 5512-X through ASA 5555-X) Priority queuing is not supported on the Management 0/0
interface.
Chapter 12 Quality of Service