Cisco ASA 5506-X Configuration Manual page 370

History for the ASA FirePOWER Module
History for the ASA FirePOWER Module
Feature
ASA 5585-X (all models) support for the
matching ASA FirePOWER SSP hardware
module.
ASA 5512-X through ASA 5555-X support for
the ASA FirePOWER software module.
ASA 5506-X support for the ASA
FirePOWER software module, including
support for configuring the module in ASDM
ASA FirePOWER passive monitor-only mode
using traffic redirection interfaces
Cisco ASA Series Firewall CLI Configuration Guide
16-30
Platform
Releases Description
ASA 9.2(2.4) The ASA FirePOWER module supplies next-generation
firewall services, including Next-Generation IPS (NGIPS),
ASA
Application Visibility and Control (AVC), URL filtering,
FirePOWER
and Advanced Malware Protection (AMP).You can use the
5.3.1
module in single or multiple context mode, and in routed or
transparent mode.
We introduced or modified the following commands:
capture interface asa_dataplane, debug sfr, hw-module
module 1 reload, hw-module module 1 reset, hw-module
module 1 shutdown, session do setup host ip, session do
get-config, session do password-reset, session sfr, sfr,
show asp table classify domain sfr, show capture, show
conn, show module sfr, show service-policy, sw-module
sfr.
ASA 9.3(2) You can run the ASA FirePOWER software module on the
ASA 5506-X. You can manage the module using
ASA
FireSIGHT Management Center, or you can use ASDM.
FirePOWER
5.4.1
ASA 9.3(2) You can now configure a traffic forwarding interface to send
traffic to the module instead of using a service policy. In this
ASA
mode, neither the module nor the ASA affects the traffic.
FirePOWER
5.4.1 We fully supported the following command:
traffic-forward sfr monitor-only. You can configure this
in CLI only.
Chapter 16 ASA FirePOWER (SFR) Module