Inserting First Card In Feed Throat - Honeywell 400 Series Hardware Manual

Figure 13. Inserting First Card in Feed Throat
Adding cards--less than 6-inch stack in hopper:
1.
2.
Inspect, fan, and joggle cards as already described.
If the handle on the feed plate is even with or lower than the operator's control
panel, stOp card feeding by pressing HALT.
Grasp a handful of the joggled cards firmly with the right hand, pick them up,
and slide the pusher plate up with the left hand to make room for the added cards.
Continue loading handfuls of prepared cards, sliding the pusher plate up each
time, until the entire card deck is loaded or the input hopper is full.
Slide the pusher plate gently down against the card deck.
Press OPERATE/RESET so that the OPERATE portion again glows. This allows
card feeding to begin when the program calls for card reading.
-40..