Honeywell FocusPRO 5000 Series Installer's Manual

InSTalleR SySTem TeST
FocusPRO 5000 Series
®
1. To begin, press and hold the s and t buttons until the
display changes.
2. Presss/t to turn system on/off.
System test System status
number number
10
0
Done Next
3. Press NEXT to advance to next test.
4. Press DONE to terminate system test.
5. Proceed to Installer System Tests on page 8.
6
FocusPRO 6000 Series
®
1. To begin, press and hold the s and t buttons until the
display changes.
2. Presss/t to turn system on/off.
System test System status
number number
10
0
Done Next
3. Press NEXT to advance to next test.
4. Press DONE to terminate system test.
5. Proceed to Installer System Tests on page 8.
7
InSTalleR SySTem TeSTS
Test the system's heating, emergency heat, cooling, and fan.
Available tests vary by thermostat and system type.
Table 2. Installer System Test
System Test Test Type System Status Number
Number and Description
10 Heating system 0 Heat and fan off
1 First stage heat
on (Fan turns on if
Setup Function 1 is
set to 1, 5, 9, or 10
OR setup Function
3 is set to 1)
2 Second stage heat
on
3 Third stage heat
on
20 Emergency 0 Heat and fan off
heating system 1 Heat and fan on
2 Second stage heat
(Aux. heat) turns on
30 Cooling system 0 Compressor and
fan off
1 Compressor and
fan on
2 Second stage
compressor on
40 Fan system 0 Off
1 On
caution
EQUIPMENT DAMAGE HAZARD.
Compressor protection is bypassed during testing.
To prevent equipment damage, avoid cycling the
compressor quickly.
8
FocusPRO 5000
®
and 6000 Series
Thermostats
InSTalleR SeTuP and
SySTem TeST POckeT GuIde
69-2026