Honeywell 400 Series Hardware Manual page 54

/°\
4
%; HOPPER 3 FEED -§ 23;? 35 PUNCH
E. ALERT §_ ALERT if FULL 2% ALERT
DATA
IN PUT
ALERT
£3 POWER 5 POWER f; DMNUAL {5 OPERATE E HALT
%' OFF :5 ON It CYCLE 2i RESET %
fl; 2'. ;:
Figure 18.
CON TROLZ INDICATOR
HOPPER ALERT indicator (blue)
FEED ALERT indicator (red)
CHAD BOX FULL indicator (blue)
PUNCH ALERT indicator (red)
DATA INPUT ALERT indicator (red)
POWER OFF pushbutton
POWER ON pushbutton and indicator
(amber)
MANUAL CYCLE pushbutton and
indicator (white)
CP 2100 Control Panel
FUNCTIONS
The indicator glows when the hopper is empty
or the stacker is full. The card punch halts.
The RESET indicator comes on.
The indicator glows to indicate a card has
failed to feed properly. The card punch halts.
The RESET indicator comes on.
The indicator glows when the chad box is full
or not prOperly positioned. RESET comes on.
The indicator glows to indicate a punch error
detected by the read brushes. DATA INPUT
ALERT indicator also comes on. The punch
may or may not halt, depending on the require-
ments of the program.
The indicator glows when a transfer timing or
transmission parity alert occurs. It also
comes on when a punch error is detected.
Punching of data stops, but the punch continues
to operate until the end of the card passes the
punch dies.
Pressing the POWER OFF control removes
power from the punch and turns off the POWER
ON light.
Pressing the POWER ON control turns on
power to the punch. The indicator comes on
only after power is fully applied (approxi-
mately 8 seconds).
The indicator glows whenever the prepunch or
the postpunch areas do not contain cards.
Pressing this control feeds a single card from
the happer to the mechanism and all cards
already in the'mechanism advance to the next
station. The indicator goes off when all stations
are properly loaded. This control is used
-45-