Honeywell 400 Series Hardware Manual page 61

CONTRO L/INBIGATOR
OPERATE/RESET pushbutton and
indicator (green/blue)
HALT pushbutton and indicator (blue)
FUNC TIONS
The blue RESET light comes on when power is
first turned on or when the punch enters
Attention status.
During punching, OPERATE goes off and RESET
glows when operation halts for one of the
following reasons: '
1. Empty input hopper
2. . Full output stacker
3. Manual halt initiated by the operator
4. Chad box too full or incorrectly
positioned
5. Feed alert
6. Card jam
7. Empty prepunch station
Pressing the control during operation st0ps
punching and feeding when the current card is
completely punched. This also makes the
MANUAL CYCLE and TRACK EJECT controls
operable.
The HALT and RESET lights come on when:
1. POWER ON is pressed (after an 8-
second delay).
2. There is an empty prepunch station.
(The MANUAL CYCLE light also
glows.)
3. The read brushes were not properly
locked into place after a card jam was
cleared from the punch block.
4. 'HALT is pressed during operations.
-52-