Honeywell 400 Series Hardware Manual page 34

CRZ201 CARD READER
Operator's Control Panel
The controls for the CRZZOl Reader are located on a panel in front of the input hopper.
See Figure 3.
The functions of the controls and indicators are described on the following pages in the
order in which they appear on the panel.
', ' POWER
' ON
POWER.
OFF
OPERATE
RESET
Figure 3. ACRZZOI Control Panel
CONTROL/INDIC ATOR
POWER ON pushbutton and indicator
(yellow)
POWER OFF pushbutton
OPERATE/RESET pushbutton and
indicator (green/blue)
READ HOPPER FEED LAST
ALERT z1
ALERT
ALERT
BATCH
FUNCTIONS
Pressing this control applies electrical power
to operate the subsystem and places the sub-
system in the Attention, Manual Halt condition.
The control is inactive if pressed within 3-4
seconds of the time POWER OFF is pressed.
Pressing this control removes all electrical
power from the subsystem and turns off the
POWER ON indicator.
Pressing this control when the RESET indicator
is on clears the Attention status, provided the
operator has corrected all inoperable conditions.
The OPERATE indicator glows green when the
card reader is ready to operate.
The OPERATE indicator goes off and RESET
glows blue to indicate that:
1. Power was turned on for the first time.
2. HALT was actuated.
3. One of the following conditions exists:
Hopper Alert
Feed Failure
Card Jam
Last Batch
Read Alert
Sneak Feed
Any time an Attention condition is cleared by
actuating" the OPERATE/RESET control, the
subsystem sends a Special Interrupt signal to
the processing system.
-25-