Honeywell 400 Series Hardware Manual page 45

CONTROL/INDICATOR FUNCTIONS
Pressing the control when the circuit is enabled
resets the control to the off state and turns off
the indicator.
RESET and HOPPER ALERT are also turned
on when the last card has been read.
FEED ALERT indicator (red) The indicator glows to indicate a card failed
to feed or a sneak feed occurred. The RESET
indicator is turned on. Card reader halts at
the end of the current operation.
HOPPER ALERT indicator (blue) The indicator glows to indicate one or more
of the following:
1. Hopper Empty
2. Hopper feed plate latched.
3. Stacker Full
Input/Output Area Switches
There are several switches located in the card reader's input and output areas (Figure 10).
Although the Operator has access to these switches, they are normally actuated by the
movement of the cards. The switches are described on the following page.
Hopper Empty Switch
Feed Plate Latch V , Stacker Riffle Air Switch
(not visible)
Stacker Full Swi .h
Figure 10. CRD150/CRZZOO Input/Output Area Switches
-35-