Honeywell 400 Series Hardware Manual page 74

Manually Returning to Operate State
If the punch is in the standby state, the reception of any instruction causes it to enter the
operate state. However, the operator can manually place the punch in the Operate state
if there are no existing Attention or Data Alert conditions. Press the following controls,
in sequence:
1. HALT
2. MANUAL CYCLE
3. OPERATE/RESET
Shutdown
To end card punching operations, follow the sequence below:
1. If it is desired to remove the three blank cards in the prepunch stations, remove
the cards from the hopper and depress the MANUAL CYCLE control.
2. Remove the punched cards from the output stacker and remove any unnecessary
blank cards from the end of the deck. Label the deck for storage.
3. Press the POWER OFF control if the punch will not be used again for some time.
When POWER OFF is pressed, the punch motors stop and all lights on the operator's
control panel go off.
-65—