Cisco 7000 Series Hardware Installation And Maintenance Manual page 284

standard 2-41
transmission distances 2-8
RS-449
cable pinouts A-8
description 2-41
port adapter 1-30
serial port adapter cable 2-38
standard 2-9, 2-41
transmission distances 2-9
RS-530
cable pinouts A-11
description 2-43
port adapter 1-30
serial port adapter cable 2-39
standard 2-43
transmission distances 2-9
RxC LED on FSIP
See LEDs
RxD LED on FSIP
See LEDs
S
safety
agency approvals 1-5
recommendations 2-2
SAS
description 2-34
LED indications B-7
network connections (illustration) 3-17
segmentation on FDDI ring 2-35
self-check messages 5-16
sensors, temperature 1-45
serial
interface processor
See FSIP
network connections (illustration) 3-22
ports, LED indications B-8
transmission distances 2-8
serial port adapters
cable pinouts A-6
cable unattached message 5-50
cables 2-38
connectors 2-38
description 1-30
replacing 5-51
setup command facility 2-45, 5-8
shipping material spare PKG-7010= 5-71
show controller cxbus command 5-50
show controllers command 5-8
show environment command 1-42, 1-45, 2-17
show environment last command 1-43
show environment table command 1-43
show interface command 1-36
Index 10 Cisco 7010 Hardware Installation and Maintenance
show interfaces command 1-36, 5-8
show version command 4-7
shutdown
environmental 1-40, 4-7
fan failure 1-45, 4-7
power supply 1-41
processor 1-41
thresholds 1-40
shutdown command 5-51
signal loss with optical bypass 1-27
Silicon Switch Processor
See SSP
single attach stations
See SAS
single-mode
FDDI cables 2-32
FIP description 1-26, 2-33
SIP 1-22
site
cabling 2-4
power 2-4
slide-type locks on EIP ports 2-26
slot
locations 1-3
numbers 1-35
slot/port addresses for interfaces 1-35
SMDS networks and CRCs 2-40
SNMP management 1-11
software
commands 1-1
minimum requirements 1-2
upgrades 1-1, 5-2, 5-30
SONET
description 2-19
HSSI support 2-43
SP
configuration 5-2
description 1-20
installation 5-2
microcode ROM replacement 5-11
normal startup 4-5
subsystem for troubleshooting 4-8
spares
descriptions 1-6
locations of 1-6
See FRUs
specifications
chassis, physical 1-5
Fast Ethernet 2-6
SRAM, FSIP 1-28
SSP
configuration 5-2
installation 5-2
microcode ROM replacement 5-11
standards