Installation Checklist; Checking The Contents Of Your Shipment - Cisco 7000 Series Hardware Installation And Maintenance Manual

Initial Configuration Information
•
•
•
•
For complete configuration instructions, refer to the related software documentation.

Installation Checklist

Use the Installation Checklist in Table 2-15 to assist you with your installation and to provide a
historical record of what was done, by whom, and when. Make a copy of this checklist and indicate
when each procedure or verification is completed. When the checklist is completed, place it in your
Site Log (described at the end of this chapter) along with the other records for your new router.

Checking the Contents of Your Shipment

Following is the procedure for checking the contents of the shipping container. Use the Installation
Checklist in Table 2-15, the Component List in Table 2-16, and the record of your order to ensure
that you received all the components you ordered.
Step 1
Step 2
Note
each system. This documentation is available on UniverCD, which can be obtained at no charge
when a router order is placed. For a complete list of documentation, see Ordering Cisco
Documentation in your warranty package.
2-46 Cisco 7010 Hardware Installation and Maintenance
Bridging configuration (whether you will use bridging and, if so, on which interfaces).
Internet Protocol (IP) addresses and subnet masks if you are routing IP.
Zone names, network numbers, or node numbers for the new interfaces if required.
Operating speeds for specific interfaces; for example, Token Ring interfaces operate at either
4 or 16 Mbps, and serial interfaces operate at speeds of up to 2 Mbps. The speed of an interface
often depends on the speed of the remote device to which it is attached.
Verify that the following are included in the shipping container (the accessories box may
be separate):
•
One Cisco 7010 router, fully assembled
•
One or more accessories boxes (some or all may be shipped separately)
Check the contents of the accessories box against the Installation Checklist and the packing
slip and verify that you received all listed equipment, which should include the following:
•
One modular power supply cord
•
One rack-mount kit (2 chassis ears and 12 mounting fasteners)
•
One cable management kit (2 cable management brackets and 6 mounting fasteners)
•
One serial port adapter cable for each FSIP port (if your system has serial interfaces),
and metric thumbscrews for each interface except V.35 for conversion if necessary
•
One jackscrew conversion kit for each EIP port (if your system has Ethernet interfaces)
•
One optical bypass cable for each FIP (if your system has FDDI interfaces)
•
Optional equipment that you ordered, such as network interface cables, transceivers, or
special connectors.
•
Router hardware and software documentation, if ordered (see the following Note)
Cisco no longer automatically ships a hard copy of the entire router documentation set with