Cisco 7000 Series Hardware Installation And Maintenance Manual page 213

Insert the two long Phillips-head screws through the two standoffs and finger-tighten them.
Step 8
These screws extend through the standoffs and the FSIP board and thread into the metal
carrier.
Install a lockwasher on each of the four jackscrews.
Step 9
On the front of the carrier faceplate, insert the four jackscrews through the front of the
Step 10
faceplate and into the holes on either side of both port connectors.
Step 11 When all screws and connectors are aligned properly, use a Phillips screwdriver to tighten
the standoff screws and a 3/16-inch nut driver to tighten the four jackscrews. Do not
overtighten any of the screws.
Proceed to the next section to reinstall the FSIP in the chassis.
Step 12
Installing and Configuring Processor Modules
Maintenance 5-55