Cisco 7000 Series Hardware Installation And Maintenance Manual page 108

Initial Configuration Information
Table 2-15
Task
Date router received
Router and all accessories unpacked
Types and numbers of interfaces verified
Safety recommendations and guidelines reviewed
Installation Checklist copied
Site Log established and background information entered
Site power voltages verified
Site environmental specifications verified
Required passwords, IP addresses, device names, and so on, available
Required tools available
Network connection equipment available
Cable management brackets installed (optional but recommended)
Router mounted in rack (optional)
Flash memory card (if present) inserted all the way into PCMCIA slot
AC power cord connected to AC source and router; retention clip secured
DC power cable connected to DC source and router; strain relief secured
Captive installation screws on RP, SP (or SSP), RSP7000, RSP7000CI, and interface processors checked
Port Configuration Worksheet completed (optional)
Network interface cables and devices connected
ASCII terminal attached to console port
Console port set for 9600 baud, 8 data bits, 2 stop bits, no parity
System power turned on (DC OK indicator is on)
System boot complete (RP Normal LED is on)
RP and SP (or SSP), or RSP7000, and all interface processors operational (enabled LED indicator on SP
[or SSP] and all interface processors is on)
Console screen displays correct hardware configuration (displayed after system banner)
System ready for global and interface-specific configuration
1. Refer to the related software documentation for first-time software configuration requirements.
2-48 Cisco 7010 Hardware Installation and Maintenance
Router Installation Checklist
1
Verified by Date