Cisco 7000 Series Hardware Installation And Maintenance Manual page 219

At the prompt, specify the framing type.
Step 4
Router(config-controller)# framing esf
Step 5 At the prompt, specify the linecode format.
Router(config-controller)# linecode b8zs
Router(config-controller)#
%CONTROLLER-3-UPDOWN: Controller T1 4/1, changed state to up
Router(config-controller)#
At the prompt, specify the channel-group modification command, channel-group and
Step 6
timeslots to be mapped. The example shows channel-group 0 and timeslots 1, 3 through 5,
and 7 selected for mapping.
Router(config-controller)# channel-group 0 timeslots 1,3-5,7
Router(config-controller)#
%LINEPROTO-5-UPDOWN: Line protocol on Interface Serial4/1:0, changed state to down
%LINEPROTO-5-UPDOWN: Line protocol on Interface Serial4/1:0, changed state to up
Router(config-controller)#
Router(config-controller)#
Step 7 At the prompt, specify the interface, serial, slot, applique, and channel-group to modify.
Router(config-controller)# int serial 4/1:0
Step 8 At the prompt, assign an IP address and subnet mask to the interface with the ip address
configuration subcommand as in the following example:
Router(config-if)# ip address 1.1.15.1 255.255.255.0
Router(config-if)#
Add any additional configuration subcommands required to enable routing protocols and
Step 9
adjust the interface characteristics.
After including all of the configuration subcommands, and to complete the configuration,
Step 10
enter Ctrl-Z (hold down the Control key while you press Z) to exit the configuration mode.
Write the new configuration to memory as follows:
Step 11
Router# write memory
The system will display an OK message when the configuration is stored.
Step 12 Exit the privileged level and return to the user level by entering disable at the prompt as
follows:
Router# disable
Router>
Step 13 Proceed to the following section to check the interface configuration with show commands.
Installing and Configuring Processor Modules
Maintenance 5-61