Table of Contents
Advertisement
Universal Motor Controller
UMC100-FBP
Technical Description
operation modes (Auto / Local ).
The following parameters are set according to the requirements (Req 1, Req, Req 5):
Settings for local mode 1 (For busfault situation)
Loc 1 Start Bus Cyc
Loc 1 Stop Bus Cyc
Loc 1 Start DI
Loc 1 Stop DI
Loc 1 Start LCD
Loc 1 Stop LCD
Loc 1 Start Bus Acyc
Loc 1 Stop Bus Acyc
Settings for Auto/Remote mode (S1 in position Remote)
Auto Start Bus Cyc
Auto Stop Bus Cyc
Auto Start DI
Auto Stop DI
Auto Start LCD
Auto Stop LCD
Auto Start Bus Acyc
Auto Stop Bus Acyc
Settings for local mode (Switch S1 in position Local)
Loc Start Bus Cyc
Loc Stop Bus Cyc
Loc Start DI
Loc Stop DI
Loc Start LCD
Loc Stop LCD
Loc Start Bus Acyc
Loc Stop Bus Acyc
The following diagram shows the simpliied UMC internal data low if S1 is in position Remote as shown
in the circuit diagram before. On the left side there are the four blocks representing the control stations.
Only three of them were required in the example. In the middle the so-called command control selection
block is displayed. On the right the starter function block is displayed. The coniguration is as above.
A cross represents a YES, an empty ield a NO. The active mode is REMOTE/AUTO as deined by S1.
Therefore the DCS can start the motor. Other start commands (as indicated by DI4) will be blocked.
UMC
Control
Stations
...
DI4
Digital
DI5
Inputs
DI0
LCD
Panel
Cyclic Bus
Telegram
Acyclic
Bus
Telegram
Bus
Super-
vision
Fieldbus
UMC100-FBP
= YES (Req. 1)
= NO
= YES (Req 5)
= YES (Req 5)
= YES (Req 5)
= YES (Req 5)
= NO
= NO
= YES (Req )
= YES (Req )
= NO
= YES (Req )
= NO
= YES
= YES
= YES
= NO
= YES (Req. 1)
= YES (Req. 1)
= YES (Req. 1)
= YES (Req. 1)
= YES (Req. 1)
= NO
= NO
0
1
0
Force Local 2
Mode
Automode
Selection
Busfault
enable
- 50 -
Starter
Function
(e.g. DOL)
Start
Stop
FieldBusPlug / Issue: 08.009
V 6
Advertisement
Table of Contents
