Table of Contents
Advertisement
Universal Motor Controller
UMC100-FBP
Technical Description
Configuration Tool
Asset Vision Basic is the tool to conigure the UMC100-FBP via a Laptop. Asset Vision Basic is jointly
used between ABB Instrumentation and ABB Control Products. Therefore it enables a wide range of
ABB products to be conigured such as motor controllers, soft starters, low meters and many more.
It is based on the FDT/DTM standard which also enables the coniguration of third-party products that
are connected at the same bus segment.
You can parameterise the UMC100-FBP both online and ofline.
In ofline mode the coniguration can be fully prepared and then later on loaded into the device(s).
If a connection to a device exists, monitoring of all measured values, maintenance counters etc. is
possible.
Coniguration
window
of the
motor protection
functions
Status Window
UMC100-FBP coniguration tool Asset Vision Basic with the motor protection coniguration
window (3). In (1) the toolbar of the tool is shown. () provides a network view with all the
devices accessible on the PROFIBUS DP line. (4) contains a window to display messages
and buttons to quit or adopt the parameter changes.
The diagram above shows the coniguration tool which allows intuitive coniguration of all
UMC100 functions.
In this example the window to conigure the motor protection parameters is shown.
In similar windows all other parameters can be conigured.
Other views enable the monitoring of the diagnosis information, the visualisation of bus monitoring,
command data and much more.
UMC100-FBP
Toolbar & Menus
- 1 -
V 6
Tree view of
all devices on
the bus line
FieldBusPlug / Issue: 11.009
Advertisement
Table of Contents
