Table of Contents
Advertisement
Universal Motor Controller
UMC100-FBP
V 6
Technical Description
Digital Inputs
Input resistor to 0 V
Cable length
Relay Outputs
Number of relay outputs
Voltage range of contacts
Lowest switched power for correct signals
Switching capacity per relay contact acc. to EN
60947-5-1 (electromagnetic load)
Short-circuit protection
Switching of inductive power
Relay contact service life
Internal clearance and creepage distances relay
contacts to 4 V circuits
Supply power down/up, behaviour: Valid for all
motor control functions, but not for transparent
and overload relay.
Digital Output
Max. output current
Short circuit protected
Output voltage if high
Isolation
Thermistor Motor Protection (PTC - binary)
Broken wire resistance
Response resistance
Reset resistance
Response time
Max. cold resistance of PTC sensor chain
Line length
Isolation
FieldBusPlug / Issue: 11.009
3.9 kΩ
unshielded max. 600 m
shielded max. 1000 m
3 x monostable with one common root
1-50 V AC/DC
1 W or 1 VA
AC-15 40 V AC: max. 1,5 A
AC-15 10 V AC: max. 3 A
DC-13 50 V DC max. 0.11 A
DC-13 15 V DC max. 0. A
DC-13 4 V DC max. 1 A
6 A gL / gG
Inductive loads need additional measures for
spark suppression. Diodes for DC voltage and va-
ristors / RC elements for AC voltage are suitable.
Some DC coil contactors contain rectiiers which
suppress sparks perfectly.
Mechanical 500 000 switching cycles
Electrical (50 V AC):
0.5 A: 100 000 cycles
1.5 A 50 000 switching
> 5.5 mm (safety insulation up to 50 V AC)
(EN 60947-1, Pollution degree )
Whenever the supply voltage of the UMC is
switched off and on, the starting of the motor
needs a new RUN signal.
00mA
Yes
UMC100 supply voltage, nominal 4VDC
No
> 4.8 kΩ
3.4 - 3.8 kΩ
1.5 - 1.8 kΩ
800 ms
< 1.5 kΩ
.5 mm
: x 50 m
1.5 mm
: x 150 m
0.5 mm
: x 50 m
No
- 13 -
UMC100-FBP
Advertisement
Table of Contents
