Section 4: Operations; Operation Overview - Grizzly G0842 Owner's Manual

SECTiON 4: OPERATiONS

Operation Overview

the purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the machine controls/components discussed later
in this manual are easier to understand.
due to the generic nature of this overview, it is
not intended to be an instructional guide. to learn
more about specific operations, read this entire
manual, seek additional training from experienced
machine operators, and do additional research
outside of this manual by reading "how-to" books,
trade magazines, or websites.
To reduce your risk of
serious injury, read this
entire
using machine.
Eye injuries or respiratory problems can
occur while operating this machine. Wear
personal protective equipment to reduce
your risk from these hazards.
if you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly industrial will not be held liable
for accidents caused by lack of training.
Model G0842 (Mfd. Since 04/18)
manual bEfORE
Typical Turning (Non-Copy)
Operations
1. operator examines workpiece to make sure
it is suitable for turning. no extreme bows,
knots, or cracks should exist.
2. prepares and trims workpiece with a bandsaw
or table saw to make it roughly concentric.
3. installs workpiece between centers, or attach-
es it to faceplate or chuck.
4.
adjusts tool rest according to type of
operation, and sets minimum clearance
between workpiece and lip of tool rest to
gap.
5.
rotates workpiece by hand to verify spindle
and workpiece rotate freely throughout full
range of motion.
6.
ties back long hair and clothing and puts on
safety glasses, face shield, and respirator.
7.
Starts lathe, pulls variable speed lever out,
and adjusts lathe speed for type of wood
and size of workpiece installed and care-
fully begins turning operation, keeping chisel
against tool rest entire time it is cutting.
8. turns lathe OFF when cutting operation is
complete.
⁄ "
1
4
-21-