Installing/Removing Faceplate Or Chuck - Grizzly G0842 Owner's Manual

Removing Tailstock Center
1.
loosen quill locking nut and rotate it up to just
touch back of live center (see figure 37).
2.
hold a clean rag under spindle or wear a
glove to catch center when you remove it
(see figure 37).
3.
rotate quill handwheel counterclockwise to
force center out of quill.
live
Center
figure 37. removing center from tailstock.
Model G0842 (Mfd. Since 04/18)
locking
nut
installing/Removing
faceplate or Chuck
use the faceplate or a chuck (see figures 38–39)
when you need to remove material from the
face of the workpiece, such as during hollowing
operations.
Note: A chuck is not included with this machine.
Refer to Accessories on Page 39 for available
chucks compatible with this machine.
figure 38. Example of faceplate installed on
spindle.
figure 39. Example of chuck installed on
spindle.
the included faceplate or a chuck can be installed
only if the spur center is removed from the spindle.
these instructions cover installing and removing
the faceplate or chuck. to mount a workpiece
to your faceplate, refer to faceplate Turning on
Page 36. to mount a workpiece to your chuck,
refer to the instructions that came with your chuck.
Faceplate
Chuck
-31-