Honeywell SmartLine SLG 700 User Manual page 126

Backgrnd Type
Use Level
(Obstacle Backgrnd
Backgrnd
Type only)
Capture
Start Capture
(capture process is
(Measured
inactive)
Prod not
Saturated
Steam)
Cancel Capture
(capture process is
active)
<Return>
Probe Type
Probe Length
Probe End Type
Probe
CenterDiskType
Note: Loop
must be
removed from
CenterDisk Dia
Automatic
Control.
(If Center Disk Type is
not None)
PropagtnFactor
Block Dist Hi
Block Dist Low
SteamRefPrbTyp
(Saturated Steam
Measured Prod only)
Steam Ref Len
(Saturated Steam
Measured Prod only)
Page 110
Field
Obstacle
Yes
No
Custom
Rod
Wire
Coax
Multi-twist
Wire
PTFE Rod
PTFE Wire
##.###
None
Clamp
Weight
Loop
None
316 SS
PTFE
C276 Ni
Alloy
2 inch to 8
inch
#.######
#.###
#.###
None
30 cm
50 cm
##.###
SLG 700 SmartLine Level Transmitter User's Manual
Background type to capture.
Use level instead of distance to
surface for Obstacle capture
length entered at time of capture.
Begins a field background
capture process, with progress
indicated by bar graph on line
immediately above. For Obstacle
captures, an entry of the capture
length is required.
Cancels the currently active field
background capture process.
Type of probe.
Length of the probe in the tank,
in Length units.
Type of probe end.
Type of centering disk
Diameter of centering disk
Probe wave propagation factor
Configures region near the
flange where measurements are
not possible and inaccurate.
Value entered is in Length units.
Configures region near the
Probe end where measurements
are not possible and inaccurate.
Value entered is in Length units.
Type of steam reference probe.
Length of Steam Reference
Probe, in Length units.
Press ↵ to
select
action
Press  to
enter menu
selection
 and  to
select
number.
 to enter
and shift to
next digit
Revision 8