Configure Regional Parameters and
Supplementary Services
Use the Regional tab to configure regional and local settings, such as control timer parameters,
dictionary server script, language Selection, and locale to change localization:
•
•
Control Timer Values (sec)
The table describes Control Timer parameters.
Field
Interdigit Long Timer
Interdigit Short Timer Short timeout between entering digits when dialing. The Interdigit Short
Control Timer Values (sec), page 7-1
Localize Your Conference Phone, page 7-2
Description
Long timeout between entering digits when dialing. The interdigit timer
values are used as defaults when dialing. The Interdigit Long Timer is
used after any one digit, if all valid matching sequences in the dial plan
are incomplete as dialed. Ranges from 0 to 64 seconds.
Setting this value high can result in a longer post dialing delay (PDD),
which is the time between the start of a call and the time the phone starts
ringing. A value that is too low can result in dialed digits not being
correctly recognized.
Defaults to 10.
Timer is used after any one digit, if at least one matching sequence is
complete as dialed, but more dialed digits would match other as yet
incomplete sequences. Ranges from 0 to 64 seconds.
Defaults to 3.
Cisco Unified IP Conference Phone 8831 for Third-Party Call Control Administration Guide
7
C H A P T E R
7-1