Localize Your Conference Phone - Cisco 8831 Administration Manual

Localize Your Conference Phone

Localize Your Conference Phone
The following table describes the localization parameters in the Voice > Regional tab under Time
section.
Field
Set Local Date
(mm/dd)
Set Local Time
(HH/mm)
Time Zone
Time Offset (HH/mm) Enter the offset from GMT to use for the local system time.
Ignore DHCP Time
Offset
Daylight Saving Time
Rule
Daylight Saving
Enable
Dictionary Server
Script
Language Selection
Locale
Cisco Unified IP Conference Phone 8831 for Third-Party Call Control Administration Guide
7-2
Chapter 7
Description
Enter the local date (mm represents the month and dd represents the day).
The year is optional and uses two or four digits. For example,
May 1, 2014, can be entered as: 05/01 or 05/01/14 or
05/01/2014.
Enter the local time (HH represents hours and MM represents minutes).
Seconds are optional.
Selects the number of hours to add to GMT to generate the local time for
caller ID generation. Choices are GMT-12:00, GMT-11:00,...,
GMT-1:00, GMT-0:00, GMT+01:00, GMT+02:00, ..., GMT+13:00.
Defaults to GMT-08:00.
When used with some routers that have DHCP with time offset values
configured, the conference phone uses the router settings and ignores the
phone time zone and offset settings. To ignore the router DHCP time
offset value, and use the local time zone and offset settings, choose Yes
for this option. Choosing No causes the IP phone to use the router's DHCP
time offset value.
The default value is Yes.
Enter the rule for calculating daylight saving time. See the
Daylight Saving Time" section on page
Select Yes to enable or No to disable DST on the phone. This setting
affects all lines (extensions) on the phone.
Defines the location of the dictionary server, the languages available, and
the associated dictionary. See the
section on page 7-5.
Specifies the default language. The value must match one of the
languages supported by the dictionary server. The script (dx value) is:
<Language_Selection ua="na">
</Language_Selection>
Defaults to blank; the maximum number of characters is 512. For
example:
<Language_Selection ua="na"> Spanish
</Language_Selection>
Choose the locale that should be set in the HTTP Accept-Language
header.
Configure Regional Parameters and Supplementary Services
7-3.
"Create a Dictionary Server Script"
"Configure