Connect To The Network; Set Up Wi-Fi Client - Cisco 8811 User Manual

Your Phone
Procedure
Step 1
Hold the receiver in the cradle with one hand.
Step 2
Move the footstand with the other hand to change the angle.
Step 3
(Optional) Adjust the footstand on the key expansion module and ensure that the phone and key expansion
module are stable.
Step 4
(Optional) Press Self-view to check the camera angle.

Connect to the Network

You need to connect the phone to the network.
• Wired network connection—The phone is plugged into the network with an Ethernet cable.
• Wireless connection—The Cisco IP Phone 8861 and 8865 can connect to a Wireless Access Point using
Wi-Fi.
• Virtual Private Network (VPN)—After the phone is connected to the network, it is set up to automatically
connect into a protected network.
Mobile and Remote Access Through Expressway—If your administrator sets up Mobile and Remote Access
Through Expressway and you connect your phone to the network, it connects to the Expressway server
automatically.

Set Up Wi-Fi Client

The Cisco IP Phone 8861 and 8865 can access a Wi-Fi network. You need a power adapter to power the
phone. The Cisco IP Phone 8865NR cannot be used with a Wi-Fi network.
Note
The phone PC port is disabled when Wi-Fi is enabled on your phone.
Before You Begin
Your administrator needs to configure settings on the call control system to enable Wi-Fi access.
ConnecttotheNetwork
Cisco IP Phone 8800 Series User Guide