Honeywell 5701 Operating Instructions Manual page 80

MAN0443.P65 Issue 13 Aug 04
05701-M-5001 A02279
CHAPTER 4 - INSTALLATION INSTRUCTIONS
AC to DC PSU Table of Sizes (mm)
8.4
43.6 31.8
5.9
PSU Assembly
8 Way
16 Way
(2) Insert the rack into the aperture and secure using M6, or similar
bolts, through the four mounting holes located upon the front flange
plates.
(3) Ensure adequate support at the rear of rear access racks.
(4) Prepare and connect the cable ends to Field Interface and Relay
Cards terminals. For terminal identification see Chapter 2. Where
possible keep sensor cables separate from the other wiring.
(5) Ensure that the rack is properly earthed by connecting a suitable
earth cable to the earth stud located at the rear of the rack.
Do not apply power to the System 57 until the commissioning
procedure has been read and understood. See Chapter 5.
A B
279.4 261.9
482.6 465.1
CAUTION
4 - 17
5701 Control System
A
B
Clearance
Width
222
443
Height
41
41