Cisco GS7000 Installation And Configuration Manual page 32

Chapter 2 Installation
Two power supplies can provide a maximum power level of 100 watts to the node or
hub node. The RF amplifier uses the majority of the available power. Maintain the
total power consumption of all modules in the housing within these guidelines to
minimize the heat generated. Find the optimal configuration by summing the power
consumption of the RF amplifier plus the other individual modules in the housing
using the following table.
Important: Do not populate the housing with any combination of modules that
would draw more than the available power of 100 watts.
The following table lists the modules and their respective power consumption.
Equipment
Transmitter
Transmitter
Transmitter
Receiver
Receiver
EDFA
EDFA
EDFA
EDFA
Optical Switch
Status Monitor/
Local Control
Module
RF Amplifier
RF Amplifier
18
Type Maximum Power
Draw (Watts)
1310 nm dfb, 4.1
analog CWDM
analog DWDM 5.4
BDR (baseband 12
digital reverse)
Note: Occupies
two slots
operating 3.4
standby 0.8
17 dBm 4.5
20 dBm 7
21 dBm 9
22 dBm 9
2
2.6
4-way forward 72.8
segmentable
2-way forward 69.6
segmentable
Typical Power
Draw (Watts)
3.4
4.8
9
2.5
0.3
4
5
7
7
1.5
0.9
69.9
67.1
OL-29937-01