Final Setup - Running Belt Tracking Adjustment - GE T2100-ST1 Operator's Manual

Assembly and Setup
WARNING:
The T2100-ST1 and T2100-ST2 treadmills conform to FCC
class B rating for electromagnetic emissions. It is
recommended not to place the treadmill closer than 5ft.
(1.5m) from sensitive electronic devices within the room or in
an adjacent room. If an interference problem occurs, move
the treadmill farther away from the sensitive device or
relocate either device to another area, or consult with an EMI
specialist for ways to shield the room from electromagnetic
radiation.
Do not place it on thick or long-pile carpeting. Such carpeting
could cause instability or static build-up, and carpet fibers
could get caught in the belt and damage the unit.
Ensure that power cords do not cross traffic areas. Exposed
power cords can cause a fall, resulting in injury.
Keep it away from sources of moisture, such as spas or
fountains. Moisture can cause the electronic circuitry to
malfunction.

Final Setup - Running Belt Tracking Adjustment

NOTE:
Because this adjustment is not covered under your warranty,
it is important that you review these instructions thoroughly
before proceeding. Uneven floors accelerate belt
misalignment. This situation may require more frequent
adjustment to prevent belt damage.
The patented MasterTrack
reduces the need to adjust the belt on your T2100-ST1 or T2100-ST2
treadmill. However, when you operate your treadmill for the first
time, you may need to adjust the tracking of the belt to conform to
your floor. You may also need to adjust the tracking if you move the
30
Belt Tracking System significantly
®
T2100-ST1 Treadmill, 110V / T2100-ST2 Treadmill, 220V 2097937-001 Rev E
12 June 2017