(3)
Remove 4 screws and take off the feeder
lower guide unit.
4.12.40 Original width detection sensor-3 (SR8)
(1)
Take off the feeder lower guide unit.
(
P.4-151 "4.12.39 Feeder lower guide
unit")
(2)
Disconnect 1 connector. Lift the actuator,
release 2 latches and take off the original
width detection sensor-3.
4.12.41 Original width detection sensor-2 (SR7)
(1)
Take off the feeder lower guide unit.
(
P.4-151 "4.12.39 Feeder lower guide
unit")
(2)
Disconnect 1 connector. Lift the actuator,
release 2 latches and take off the original
width detection sensor-2.
e-STUDIO556/656/756/856(Ver03)
DISASSEMBLY AND REPLACEMENT
Original width detection sensor-3
Original width detection sensor-2
© 2012 TOSHIBA TEC CORPORATION All rights reserved
4 - 152
Fig. 4-432
Fig. 4-433
Fig. 4-434